Professor of Electrical and Electronics Engineering
Abdullah Atalar senior project students
Kürşat Albayraktaroğlu (now a design engineer at Intel, Austin TX) “Design and implementation of a PCI bus interface for atomic-force-microscope”
Engin Avcı “Design of a four-layer PCB board of a communication system” (Jan 2000)
Engin Avcı and İlhan Kaya “Design of a low-noise microwave amplifier” (June 2000)
Elif Aydoğdu (ASELSAN) “Design and simulation of MEMS variable capacitor based mechanical to electrical energy converter unit” (Jun 2004)
Mehmet Emin Başbuğ (Researcher at Lion Cave Capital) “Design and implementation of a laser Doppler vibrometer to measure vibrations of CMUTs”
Barış Bayram (Assoc Prof at METU) “Turns-ratio and figure of merit comparison of mushroom-shaped and drum-shaped CMUTs” (May 2000)
Barış Bayram “Harmonic analysis of mushroom-shaped and drum-shaped CMUTs under stress” (Dec 1999)
Can Bayram (Assist Prof at Univ of Illinois at Urbana-Champaign) “Gain-bandwidth product and bandwidth improvement in CMUT array with mixed size cells” (May 2005)
Said Boybay (Assist Prof at Antalya International Univ) and Emre Togan (ETH Zurich) “Focusing of acoustic waves in planar layered media” (Jan 2004)
Said Boybay and Emre Togan “Designing and efficient lens for focusing acoustic waves in planar media” (Jun 2004)
Volkan Cevher (Prof at EPFL) “Design and simulation of an operational amplifier; Building block for a photodetector array and an instrumentation amplifier”
Abdullah Çelik (Product Line Director, Analog Devices) “Cross-coupling in CMUT arrays”
Abdullah Çelik “Finite-element modeling of cross-coupling in CMUTs”
İlker Deligöz “Theory and analysis of electrode-size optimization for CMUTs” (Jan 2002)
İlker Deligöz “Comparison of finite-element and numerical solutions of CMUTS” (Jun 2002)
Kaya Demir “Electrical circuit modeling of atomic-force-microscope tip-sample interactions”
Ali Özer Ercan (Assist Prof at Özyeğin Univ) “Improvement of a CMOS OPAMP”
Tamer Güdü “Design of a high-voltage multichannel operational amplifier”
Gökçe Keskin “MEMS detection in MRI” (May 2003)
Cihan Kıykaç (Bus. Dev. Director at Citus Power) “Design of a (31,23) Reed-Solomon encoder for error-correction coding”
Çağla Kıvılcım Koru “Design of a flyback-converter” (Jun 2005)
Alper Kiraz (Prof at Koç Univ) and Alaeddin Aydıner “Design, simulation and implementation of an instrumentation amplifier” (Dec 1997)
Hakan Köklü “Improvements in the performance of CMUT by using non-uniform membrane structures”
Selçuk Köse and Burak Şekerlisoy “Implementation of an adaptive digital predistortion for linearization of RF amplifiers”
Kıvanç Mıhçak (Quantitative trader at Jump Trading, Chicago) and Mücahit Kozak (Senior manager at Synaptics, Austin TX) “VHDL coding of DTMF receiver simulation and optimization using Synopsys” (Jan 1996)
Erdinç Mutlu “Design and implementation of the PCI bus interface of the atomic-force-microscope”
Sedat Nizamoğlu (Assist Prof at Koç Univ) “Adaptive digital predistortion techniques for linearization of RF amplifiers”
Selim Olçum (Co-founder and Director of Engineering at Travera) “Comparison of mushroom and drum shaped CMUTs”
Mehmet Önsiper and Soner Başaran (R&D manager at Polen Seed Company) “Application specific processor of LDPC decoder”
Erhan Özalevli (IC design engineer at Texas Instruments) “A ROM based correlator design and test software for a radiolink”
Mustafa Özdal (Assist Prof at Bilkent) “Software for atomic-force-microscope”
Bülent Özel (Data Science Consultant, Researcher and Lecturer, Universitat Jaume I) “PCI bus interface for atomic-force-microscope”
Mehmet Özgür (Engineer at MNX, Virginia) “Design and implementation of 10MHz to 2GHz medium-power RF amplifier”
Zehra Parlak (Founder and Acting CEO at QATCH Technologies) and Duygu Kuzum (Assist Prof at UCSD) “Non-destructive method for subsurface defect size detection”
Fatih Sarıoğlu (Assist Prof at Georgia Tech) “Non-destructive detection of subsurface cracks and disbonds using AFM” (Jan 2003)
Zekeriya Şahin (Program manager at ASELSAN) “Designing a pacemaker involving fiber-optic communication channel between generator and cardiac” (May 2005)
Muhammed Şenlik (Senior expert engineer at ASELSAN) “Amplifier linearization techniques” (Jul 2001)
Şennur Ulukuş (Prof at Univ of Maryland) “A rootfinder program written in C programming language” (Jan 1991)
Can Uran (Senior optical systems design engineer at Vestel Electronics) “Area efficient 5-bit DAC”
Mustafa Yazgan (Software engineer at Google) “Writing a graphics program for viewing 3D inputs: GrView”
Mustafa Yazgan “Writing a graphics interface for PLAWE and SPICE simulator outputs”
Hüseyin Yavuz (ASELSAN) “Design of an EPROM programmer” (Jul 1985)
Özlem Yılmaz (ASELSAN) and Makbule Pehlivan (Engineer at STM) “Variable MEMS capacitor design for mechanical energy to electrical energy converters” (May 2005)